Siemens SX763 - Manual (Page 108)

108
Administration
Gigaset SX763 WLAN dsl/ en / A31008-M707-R131-2-7619 / admin_router.fm / 08.12.2006
Sc
hablone 2
005_0
5_02
Restoring factory settings
You can reset the Gigaset SX763 WLAN dsl to the factory settings. You should do this
before making the device available to others or exchanging it through the dealer. Oth-
erwise unauthorised persons may use the Internet access data at your expense.
ì
Select Reset configuration to factory default settings and click OK.
A window will appear prompting you to confirm the procedure.
Reboot
If the Gigaset SX763 WLAN dsl is not operating properly, you can reboot it. It should
then be ready for use again.
In the Administration menu, select Reboot.
Click OK to reboot the device.
Updating firmware
If Siemens or your Internet service provider releases a new version of the firmware, you
can update the firmware of the Gigaset SX763 WLAN dsl. To do this you must first load
the new firmware onto your PC.
Carry out the following steps:
ì
End all network activities in the local network.
ì
In the Advanced Settings – Administration menu, select Firmware Update.
Note:
If the Gigaset SX763 WLAN dsl is not operating properly, you can reboot it. It should
then be ready for use again (page 21).
Please remember that when the device is fully reset, all the configuration settings are
returned to the factory settings. This means that you will have to completely reconfig-
ure the Gigaset SX763 WLAN dsl.