Siemens SX763 - Manual (Page 114)

114
Status information
Gigaset SX763 WLAN dsl/ en / A31008-M707-R131-2-7619 / admin_router.fm / 08.12.2006
Sc
hablone 2
005_0
5_02
Shows the public IP address of the device.
u PPPoE pass-through
Shows the status of PPPoE pass-through for the DSL or cable connection for estab-
lishing an Internet connection directly between a PC and the network.
u ADSL Line
– Status
The status of the cable connection from your device to your DSL port.
– Line mode
The current line mode used by your DSL port.
– Maximum line rate
The maximum possible data transfer rate of your DSL port for incoming and out-
going data traffic.
– Noise margin
The maximum signal-to-noise ratio of your DSL port for incoming and outgoing
data traffic.
– Line attenuation
The line attenuation of your DSL port for incoming and outgoing data traffic.
– Output power
The output power of your DSL port for incoming and outgoing data traffic.
u Address Translation (NAT)
– Status
Shows the status of the NAT (Network Address Translation) for the Internet con-
nection.
– NAT table
Shows the current number of entries in the NAT table.
Click Empty to delete all the current entries in the NAT table.
ì
Click Refresh to refresh this screen and update the displayed data.
Local Network
You will find information about the local network settings on the Local Network screen
in the Status menu.
u IP address
Shows the local IP address of the device.
u Subnet mask
Shows the subnet mask used in the local network.
u MAC address
Shows the local MAC address of the device for wired data transfer.
u DHCP Server
– Status