Symbol Technologies Spectrum24 AP-4131 - Manual (Page 81)

Configuring the AP
AP-4131 Access Point Product Reference Guide 71
2.5 Configuring Radio Parameters
The AP automatically configures most radio parameters. Only advanced
users, Symbol trained users or Symbol representatives should adjust the
radio parameters for the AP or the options in the RF Configuration screen.
1. Select Set RF Configuration from the Main Menu to display:
Symbol Access Point
RF Configuration
.DTIM Interval 10 WLAP Mode Disabled
.BC/MC Q Max 10
.Max Retries (d) 15 WLAP Priority 8000 hex
.Max Retries (v) 5 WLAP Manual BSS ID 00:00:00:00:00:00
.Multicast Mask (d) 09000E00 hex
.Multicast Mask (v) 01005E00 hex WLAP Hello Time 20
.Beacon Interval 100 K-us WLAP Max Age 100
.Accept Broadcast ESSID Enabled WLAP Forward Delay 5
.MU Inactivity Timeout 60 min. WLAP MU Table Aging Time 240 min.
.Rate Control
11 Mb/s Optional
5.5 Mb/s Optional
2 Mb/s Required
1 Mb/s Required
.RTS Threshold 2347 bytes
.Short RF Preamble Disabled
.Extended Range 0 mi. Tx Power Control Full
EPP Setup - [F3]
EIAP Setup - [F4]
OK-[CR] Save-[F1] Save All APs-[F2] Cancel-[ESC]
The frequency of DTIM packets as a multiple of TIM packets. Range(1..255)
The dot in front of certain parameters, functions or options (for example
.Rate
Control
) indicates these items update to all APs with the same Net_ID (ESS)
when choosing the
Save ALL APs-[F2]
option. Users can perform this option
only among the same hardware platforms and same firmware versions.