Symbol Technologies Spectrum24 AP-4131 - Manual (Page 65)

Configuring the AP
AP-4131 Access Point Product Reference Guide 55
3. Select AP Installation from the Main Menu:
Symbol Access Point
MAIN MENU
Show System Summary AP Installation
Show Interface Statistics Special Functions
Show Forwarding Counts Set System Configuration
Show Mobile Units Set RF Configuration
Show Known APs Set Access Control List
Show Ethernet Statistics Set Address Filtering
Show RF Statistics Set Type Filtering
Show Misc. Statistics Set SNMP Configuration
Show Event History Set Event Logging Configuration
Enter Admin Mode
4. Verify the AP parameters reflect the network environment. Change them
as needed.
5. Press TAB to scroll to the item and press ENTER to select.
Symbol Access Point
Access Point Installation
.Country Config-[CR] United States
Unit Name Symbol Access Point
IP Address 157.235.95.174
.Additional Gateways
.Gateway IP Address 0.0.0.0 0.0.0.0 0.0.0.0
0.0.0.0 0.0.0.0
.Subnet Mask 255.255.0.0 0.0.0.0 0.0.0.0
111.111.12.1
.DNS IP Address 0.0.0.0
.Net_ID (ESS) 101
.Additional DNS
.Antenna Selection Full Diversity 157.235.95.229 0.0.0.0
.DHCP/BOOTP Enabled
OK-[CR] Save-[F1] Save All APs-[F2] Cancel-[ESC]
(Most parameters take effect only after being saved and AP is reset)