Symbol Technologies Spectrum24 AP-4131 - Manual (Page 166)

Configuring the AP
156 AP-4131 Access Point Product Reference Guide
2.18 Saving the Configuration
The AP keeps only saved configuration changes after a reset. To make
configuration changes permanent, save changes as needed.
To save all changes:
Press F1 in the configuration screens displaying the
Save
option or complete
the following procedure:
1. Select Special Functions from the Main Menu to display:
Symbol Access Point
Special Functions Menu
Clear All Statistics Restore Factory Config.
Clear MU Table Save Configuration
Clear ACL Save Config. to All APs
Clear Address Filters
Clear Type Filters Firmware Update Menu-[F3]
Load ACL from File via TFTP
Load ACL from File via XMODEM
Load ACL from MU List
Reset AP
Security Configuration
Configure Kerberos
Configure EAP-TLS
Configure WEP Encryption
Configure Network Time
Exit-[ESC]
2. Select Save Configuration and press ENTER.
The
Save Config. to All APs
function does not save every
configuration parameter when selected. Users can perform this option
only among the same hardware platforms and firmware versions. The
NVRAM stores saved configuration information. To clear the NVRAM-
stored configuration, see section 2.20: ”Restoring the Factory
Configuration” on page 157.