Symbol Technologies Spectrum24 AP-4131 User Manual
Page 75
Configuring the AP
AP-4131 Access Point Product Reference Guide
65
3. To enable or disable interfaces on the AP, modify the following
parameters:
4. Verify the values set reflect the network environment.
Change as needed.
5. Select
OK
or
Save
to register settings by writing changes to NVM.
Selecting
Save
displays a confirmation prompt.
6. Select
Save ALL APs
or press
[F2]
to save the System Configuration
information to all APs with the same Net_ID (ESS).
This option saves the configuration changes for the current AP, sends two
WNMP messages to all other APs on the Known APs table to update their
configuration and resets after the configuration has been modified.
Users can perform this option only among the same hardware platforms
and firmware version.
7. The system prompts
Warning Update, save, and reset all APs in the Known AP Menu?
yes no
Type
Y
.
8. Select
Cancel-[ESC]
to disregard any changes made to this screen and
return to the previous menu.
Ethernet
Interface
Enables or disables wired Ethernet.
The default value is On.
RF Interface
Enables or disables radio. The default value is On.
Default Interface Specifies the default interface (
Ethernet
,
WLAP
or
Reserved
) that the AP forwards a frame to if the AP
cannot find the address in its forwarding database.
The default interface is Ethernet. The AP defaults to
Ethernet
when
Reserved
is selected.