Symbol Technologies Spectrum24 AP-4131 - Manual (Page 73)

Configuring the AP
AP-4131 Access Point Product Reference Guide 63
Access
Control Allows the user to set one of three Access Control
modes: Disabled, Allowed, or Disallowed.
•
When
Disabled
(default) is selected, no filtering
is performed.
• When
Allowed
is selected, only MAC addresses
specified in the Access Control List are allowed
to associate with the AP.
• When
Disallowed
is selected, only MAC
addresses not specified in the Disallowed
Addresses List (Address Filtering) are allowed
to associate with the AP.
Type Filtering Specifies filter type for packets received either
Forward/Discard or Disabled.
The default value is
Disabled
.
WNMP
Functions Specifies if the AP can perform WNMP functions.
The default value is
Enabled
.
AP-AP State
Xchg Specifies AP-to-AP communication exchanged.
Max
Associated
MUs Specifies the maximum number of MUs (127) that
are allowed to associate with the access point.
MU-MU
Disallowed If enabled, mobile units associated with the same
AP are not allowed to communicate with each
other.
Modem
Connected The default setting is
No
. Set to
Yes
when using a
dial-up configuration.
Inactivity
Timeout The inactivity time on the UI that causes the AP to
terminate the connection while using a modem.
The default is
5
minutes from a
0
to
100
-minute
range.
The
0
value indicates no time-out.