SATO HT200e - Manual (Page 51)

SECTION 2: INSTALLATION AND SETUP
SATO HT200e Page 2-33
PROCESS ON THE SCREEN FOR INDICATION OF ROM VERSION
9 + Power “ON”
[ ← ] [ → ]
[ ← ] [ → ]
[ ← ] [ → ]
[ ← ] [ → ]
Ｔ Ｅ Ｓ Ｔ Ｐ Ｒ Ｉ Ｎ Ｔ
1
Ｂ Ａ Ｔ Ｔ Ｅ Ｒ Ｙ Ｃ Ｈ Ｅ Ｃ Ｋ
2
Ｒ Ａ Ｍ Ｂ Ａ Ｃ Ｋ Ｂ Ａ Ｔ Ｔ Ｅ Ｒ Ｙ
3
Ｃ Ａ Ｒ Ｄ Ｂ Ａ Ｔ Ｔ Ｅ Ｒ Ｙ
4
Ｒ Ｏ Ｍ Ｖ ｅ ｒ ．
5 １ Ｗ ０ ０ ０ ０
Press [ENTR], so that it displays voltage in battery.
Press [
← ], so that it returns to the process No. 1.
Press [ → ], so that it goes to the process No. 3.
Press [ENTR], so that it starts test print.
Press [
→ ], so that it goes to the process No. 2.
Press [ENTR], so that battery level (or remaining
fuel) can be indicated for RAM’s back-up.
Press [
← ], so that it returns to the process No. 2.
Press [ → ], so that it goes to the process No. 4.
ROM version can be displayed:
[ENTR] is invalid.
Press [
← ], so that it returns to the process No. 4.
Press [ENTR], so that battery level (or remaining
fuel) can be indicated for card’s back-up.
Press [
← ], so that it returns to the process No. 3.
Press [ → ], so that it goes to the process No. 5.