Process on the screen for ean country code setting – SATO HT200e User Manual
Page 47
![background image](/manuals/144446/47/background.png)
SECTION 2: INSTALLATION AND SETUP
SATO HT200e
Page 2-29
PROCESS ON THE SCREEN FOR EAN COUNTRY CODE SETTING
6 + Power “ON”
[
← ]
[
→ ]
[
← ]
[
→ ]
[
← ]
[
→ ]
[
← ]
[
→ ]
[
← ]
[
→ ]
[
← ]
[
→ ]
[
← ]
[
→ ]
Note: When EAN COUNTRY CODE is entered, or when either AC is pressed without no numeric entry or [
← ] or
[
→ ] is used after entering value in 1 digit (or less than 2 digits), DEFAULT will return to 50.
P A R A M E T E R
C O P Y
1
P R I N T E R
← →
C A R D
D A T A
S T O R E / R C A L L
2
P R I N T E R
← →
H O S T
P R E S E T
S T R / R C A L L
3
P R I N T E R
← →
H O S T
F O N T
S T O R E / R C A L L
4
P R I N T E R
← →
H O S T
T A B L E
S T R / R C A L L
5
P R I N T E R
← →
H O S T
C U R R E N C Y
S E L E C T
6
C A R D
C L E A R
7
E A N
C O U N T R Y
C O D E
8
5
0
Press [ENTR], so that it goes to the screen for the
selection of transferring print parameter.
Press [
← ], so that it returns to the process No. 1.
Press [
→ ], so that it goes to the process No. 3.
Press [ENTR], so that it goes to the screen for the
selection of copying print parameter.
Press [
→ ], so that it goes to the process No. 2.
Press [ENTR], so that it goes to the screen for the
selection of transfering preset.
Press [
← ], so that it returns to the process No. 2.
Press [
→ ], so that it goes to the process No. 4.
Press [ENTR], so that it goes to the screen for the
selection of transfering font.
Press [
← ], so that it returns to the process No. 3.
Press [
→ ], so that it goes to the process No. 5.
Press [ENTR], so that it goes to the screen for the
selection of transfering table data.
Press [
← ], so that it returns to the process No. 4.
Press [
→ ], so that it goes to the process No. 6.
Press [ENTR], so that it goes to the screen for the
selection of currency mark.
Press [
← ], so that it returns to the process No. 5.
Press [
→ ], so that it goes to the process No. 7.
Press [ENTR], so that it goes to the screen for the
selection of the card clear type.
Press [
← ], so that it returns to the process No. 6.
Press [
→ ], so that it goes to the process No. 8.
[0] to [9] can be set in 2 digits, so that it permits the
entry ranging from 00 to 99.
Press [
← ] , so that it returns to the process No. 7.