SATO HT200e - Manual (Page 12)

VIII SATO HT200e
-
How to Handle PC Card:
- Battery shall be set before using PC card. If it is not set properly, data in
the card can not be retained.
- DO NOT DROP or BEND the PC Card , this may cause data lost
- DO NOT CONT ACT WITH WATER. This may cause the data stored to
be lost.
- DO NOT EXPOSE to DIRECT LIGHT or PLACE AT OR NEAR HEAT-
ING EQUIPMENT.
- DO NOT TOUCH the connector portion and AVOID DUST or DIRT. This
may cause the data recorded to be lost.
- DO NOT PLACE in an environment with high temperature & humidity
- PUT THE CARD INTO SOFT CASE when transporting
as to avoid static electricity.
Replacement of Battery Pack:
- DO NOT USE battery pack other than specified.
- Take note of the polarity - (positive and negative) when chang-
ing the battery. So FOLLOW the instruction. If not followed, the battery
may leak or be damaged that will result you in hurt or injury, or perhaps
smear in your working environment.
- CONTACT a dealer, sales representative office, or service centers
WHEN DISPOSING THE BATTERY AFTER REPLACEMENT.
- For the package, DO NOT IMPACT or THROW OUT.
- DO NOT USE or PLACE IN THE ENVIRONMENTS, where the pack is
exposed BY DIRECT LIGHT, or in a room, the inside of a car, or near the
heating equipment AT HIGH TEMPERATURES. This may cause battery
leak or degrade the performance and/or life of the battery.
- BE SURE TO CHARGE the battery before use for the initial exposure or
when it is used prolonged.
- KEEP FIRMLY AT LESS MOISTURE PLACE when the pack is not
used, so that it will prevent it from the battery leak or rust.
- USE CLEANED-UP TERMINAL by wiping it with dried cloth when the
terminal of the battery pack becomes dirt. If NOT CLEANED, contact
with equipment may degrade or it may cause the battery charge in
trouble.
Warning
SAFETY PRECAUTIONS