SATO HT200e - Manual (Page 50)

SECTION 2: INSTALLATION AND SETUP
Page 2-32 SATO HT200e
PROCESS ON THE SCREEN FOR VOLTAGE INDICATION OF CARD BACKUP
MEMORY
9 + Power “ON”
[ ← ] [ → ]
[ ← ] [ → ]
[ ← ] [ → ]
[PGUP] [ENTR]
Note: Where card is not connected, there can not be seen any descriptions in the second line. For Service
Maintenance Mode, FULL/EMPTY can be made available for the voltage indication of card back-up
memory. The voltage can not be displayed. Whether the voltage is FULL or EMPTY will become available
for the back-up memory when power is applied.
Ｔ Ｅ Ｓ Ｔ Ｐ Ｒ Ｉ Ｎ Ｔ
1
Ｂ Ａ Ｔ Ｔ Ｅ Ｒ Ｙ Ｃ Ｈ Ｅ Ｃ Ｋ
2
Ｒ Ａ Ｍ Ｂ Ａ Ｃ Ｋ Ｂ Ａ Ｔ Ｔ Ｅ Ｒ Ｙ
3
Ｃ Ａ Ｒ Ｄ Ｂ Ａ Ｔ Ｔ Ｅ Ｒ Ｙ
4
Ｃ Ａ Ｒ Ｄ Ｂ Ａ Ｔ Ｔ Ｅ Ｒ Ｙ
Ｂ Ａ Ｔ Ｔ Ｅ Ｒ Ｙ Ｆ Ｕ Ｌ Ｌ
Press [ENTR], so that it displays voltage in battery.
Press [
← ], so that it returns to the process No. 1.
Press [ → ] , so that it goes to the process No. 3.
Press [ENTR], so that it starts test print.
Press [
→ ], so that it goes to the process No. 2.
Press [ENTR], so that battery level (or remaining
fuel) can be indicated for RAM’s back-up.
Press [
← ], so that it returns to the process No. 2.
Press [ → ], so that it goes to the process No. 4.
Press [ENTR], so that battery level (or remaining
fuel) can be indicated for card’s back-up.
Press [
← ], so that it returns to the process No. 3.
Press [PGUP], so that it returns to the screen for the
selection of battery level indication for cards
back-up.