Siemens Simatic 620 - Manual (Page 81)

SIMATIC Box PC 620 Expansions
4-21
SIMATIC Box PC 620 Manual
A5E00131465-01
4.5.4 Removal and Installation of the LS 240 Drive
The removal and installation of the LS240 drive takes place with the same steps as
for the floppy drive.
1. Open the housing as described in Section 4.1.
2. Remove the drive holder as described in Section 4.5.1.
3. Release the cable clamp assembly of the controller flex-lead on the
motherboard and pull the flex-lead out of the connector assembly.
4. Undo the two fixing screws (TORX T8) on the housing.
5. Lift the LS 240 drive upwards out of the housing.
6. Proceed in the reverse order to fit the new drive.
Fixing screws of the LS 240 drive
Screw for LS 240 cable clamp assembly
Figure 4-16 Installation of the LS 240 Drive