Siemens Simatic 620 - Manual (Page 181)

Reinstallation of the Software
8-11
SIMATIC Box PC 620 Manual
A5E00131465-01
8.3 Installing Drivers and Software
To install the drivers and software from the “Documentation and Drivers” CD
supplied, proceed as follows:
S Place the CD in the CD ROM drive.
S Start the Start programm on the CD.The Acrobat Reader is started by the CD.
S Navigate to the driver list (language, operating system and device dependent).
S Please install the corresponding driver according to driver list.
Notice
When reinstalling Windows 98 and Windows 2000, make sure to install the chip
set driver prior to the other drivers.
When reinstalling Windows NT, the Windows NT ServicePack has to be installed
prior to all the other drivers. The Service Pack has to be reinstalled after a driver
installation.
8.4 Installing and Operating the Burner Software
A burner software is not installed in the delivery condition. You will find instructions
on installing and operating the burner software on the supplied CD ROM for the
burner software.