Siemens Simatic 620 - Manual (Page 80)

SIMATIC Box PC 620 Expansions
4-20
SIMATIC Box PC 620 Manual
A5E00131465-01
4.5.3 Removal and Installation of the Floppy Drive
1. Open the housing as described in Section 4.1.
2. Remove the drive holder as described in Section 4.5.1.
3. Release the interlock of the controller flex-lead on the motherboard and pull the
flex-lead out of the connector assembly.
4. Undo the two fixing screws (TORX T8) on the housing.
5. Lift the floppy drive upwards out of the housing.
6. Proceed in the reverse order to fit the new drive. The new drive must be of the
same type as the one removed.
Fixing screws of the floppy drive
Figure 4-15 Installation of the Floppy Disk Drive in the Box PC 620