Siemens Simatic 620 - Manual (Page 117)

Configuring the SIMATIC Box PC 620
5-29
SIMATIC Box PC 620 Manual
A5E00131465-01
5.1.8 Default Setup Settings
Documenting Your Device Configuration
If you have made any modifications to the default Setup settings, you can enter
them in the following table. You can then refer to these entries if you need to make
any hardware modifications later.
Note
Print the following table out and keep the pages in a safe place once you have
filled in your entries.
Systemparameter Default Settings YourEntries
Main
System Time
hh:mm:ss
System Date MM/TT/JJJJ
Diskette A 1,44 MB, 3 1/2”
bei LS 240: Disabled
Primary Master C: 20496 MB
Primary Slave None
Secondary Master CD–ROM
Secondary Slave None
Memory Cache Write back
Boot Options
Quick Boot Mode
Enabled
SETUP prompt Enabled
POST Errors Enabled
Floppy check Disabled
Summary screen Enabled
Keyboard Features
Num Lock
On
Key Click Disabled
Keyboard auto-repeat rate: 30/s
Keyboard auto-repeat delay 1/2s
Hardware Options
PCI-MPI/DP:
Enabled
On Board Ethernet Enabled
Ethernet Adress 08000624xxxx
LAN remote boot Disabled
Cardbus/PCMCIA Slot Enabled
SafeCard Functions Enabled
Legacy USB Support Disabled