Juniper Networks J4350 - Manual (Page 96)

J4350 and J6350 Services Router Getting Started Guide
Router Power Requirements
Table 31 lists the AC and DC power system electrical specifications
for J-series Services Routers.
Table 31: AC and DC Power System Electrical Specifications
Item Specification
AC input voltage 100 to 240 VAC nominal
AC input line frequency 50 to 60 Hz
AC system current rating J4350 Services Routers: 6 A
J6350 Services Routers: 8 A
DC input voltage –48 to –60 VDC operating range
DC system current rating 20 A
AC Power, Connection, and Power Cord Specifications
NOTE: The AC power cord for the Services Router is intended for use with the
router only and not for any other use.
Detachable AC power cords, each 2.5 m (approximately 8 ft) long, are supplied
with the Services Router. The appliance coupler at the female end of the cord
inserts into the appliance inlet on the faceplate of the AC power supply. The
coupler is type C19 as described by International Electrotechnical Commission
(IEC) standard 60320. The plug at the male end of the power cord fits into the
power source receptacle that is standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 4.5 m (approximately
14.75 ft) in. length, to comply with National Electrical Code (NEC) Sections 400-8
(NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section 4-010(3).
The cords supplied with the router are in compliance.
Table 32 lists power cord specifications and Figure 28 illustrates the plug on
the AC power cord provided for each country or region.
Table 32: AC Power Cord Specifications
Country Electrical Specifications Plug Standards
Australia 250 VAC, 10 A, 50 Hz AS/NZ 3112–1993
China 250 VAC, 10 A, 50 Hz GB2099.1 1996 and GB1002 1996 (CH1-10P)
76 Power Guidelines, Requirements, and Specifications