Juniper Networks J4350 - Manual (Page 227)

Safety and Regulatory Compliance Information
Warning Statement for Norway and Sweden on page 215
In Case of Electrical Accident on page 215
Multiple Power Supplies Disconnection Warning on page 215
Power Disconnection Warning on page 217
TN Power Warning on page 218
Telecommunication Line Cord Warning on page 219
General Electrical Safety Guidelines
Install the Services Router in compliance with the following local, national, or
international electrical codes:
United States—National Fire Protection Association (NFPA 70), United
States National Electrical Code.
Canada—Canadian Electrical Code, Part 1, CSA C22.1.
Other countries—International Electromechanical Commission (IEC)
60364, Part 1 through Part 7.
Evaluated to the TN power system.
Locate the emergency power-off switch for the room in which you are working
so that if an electrical accident occurs, you can quickly turn off the power.
Do not work alone if potentially hazardous conditions exist anywhere in
your workspace.
Never assume that power is disconnected from a circuit. Always check the
circuit before starting to work.
Carefully look for possible hazards in your work area, such as moist floors,
ungrounded power extension cords, and missing safety grounds.
Operate the Services Router within marked electrical ratings and product
usage instructions.
For the Services Router and peripheral equipment to function safely and
correctly, use the cables and connectors specified for the attached peripheral
equipment, and make certain they are in good condition.
Many Services Router components can be removed and replaced without powering
down or disconnecting power to the Services Router, as detailed in elsewhere
in this manual. Never install equipment if it appears damaged.
Safety Guidelines and Warnings 207