Juniper Networks J4350 - Manual (Page 145)

Chapter 9
Configuring Autoinstallation
If you are setting up many J-series Services Routers, autoinstallation can help
automate the configuration process. You can use either the J-Web configuration
editor or CLI configuration editor to configure autoinstallation. The J-Web interface
does not include Quick Configuration pages for autoinstallation.
This chapter contains the following topics:
Autoinstallation Terms on page 125
Autoinstallation Overview on page 126
Before You Begin on page 127
Configuring Autoinstallation with a Configuration Editor on page 128
Verifying Autoinstallation on page 129
Autoinstallation Terms
Before configuring autoinstallation, become familiar with the
terms defined in Table 41.
Table 41: Autoinstallation Terms
Term Definition
autoinstallation Automatic configuration of a Services Router when it is powered
on without a valid configuration file or is configured specifically for
autoinstallation. Autoinstallation is useful when deploying multiple
Services Routers.
default configuration Configuration state when a boot file cannot be located during
autoinstallation.
host-specific configuration Configuration state when a specific filename is used during TFTP
server requests.
Autoinstallation Terms 125