Juniper Networks J4350 - Manual (Page 149)

Configuring Autoinstallation
4. To check the configuration, see “Verifying Autoinstallation” on page 129.
Table 42: Configuring Autoinstallation
Task J-Web Configuration Editor CLI Configuration Editor
Navigate to the System level in the
configuration hierarchy. 1. In the J-Web interface, select
Configuration>View and Edit>
Edit Configuration.
2. Next to System, click Configure or
Edit.
From the [edit] hierarchy level, enter
edit system
Enable autoinstallation. Select Autoinstallation, and then click
Configure.
Add the configuration servers by
specifying the URL address of a server
from which to obtain configuration files. 1. Next to Configuration servers, click
Add new entry.
2. Type the location of the
configuration server in the Url box.
3. If a password is required to access
the server, type it into the Password
box.
4. Click OK to return to the
Autoinstallation page.
Enter set autoinstallation configuration
servers url .
Configure one or more Ethernet or serial
interfaces to perform autoinstallation,
and one or two procurement protocols
for each interface. The router uses the
protocols to send a request for an IP
address from the interface.
BOOTP—Sends requests over
all interfaces.
RARP—Sends requests over
Ethernet interfaces.
SLARP—Sends requests over
serial interfaces.
1. Next to Interfaces, click Add new
entry.
2. Type the name of the interface into
the Interface name box.
3. Select one or two types of protocol
used by autoinstallation over the
interface. You can select Bootp,
Rarp, or Slarp.
4. Click OK to return to the
Autoinstallation page.
Enter set autoinstallation interfaces
interface-name
, then one of the
following protocols:
bootp
rarp
slarp
For example, to set two address
procurement protocols, enter a
command like the following example:
set autoinstallation interfaces ge-2/0/0
bootp rarp
Verifying Autoinstallation
To verify that a Services Router is configured for autoinstallation,
perform the following task.
Verifying Autoinstallation Status
Purpose Display the status of the autoinstallation feature on a Services Router.
Verifying Autoinstallation 129