Juniper Networks J4350 - Manual (Page 166)

J4350 and J6350 Services Router Getting Started Guide
Figure 39: Removing a PIM
1 4
5
6 2
3
SLOT N UMBE R
E E E
E
POWER
PO WER ST ATUS
ALARM
HA
RESET
CONSOLE AUX USB
1
0
CONFIG
10/100/1000
g003817
S E R IAL
PORT 0
STATUS
PORT 1
STATUS
Captive screws
Installing a PIM
CAUTION: Do not hot-swap PIMs. Failure to power off the router before removing
or installing a PIM might result in damage to the hardware.
To install a PIM (see Figure 40):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the Services Router is disconnected from earth ground. For more information
about ESD, see “Preventing Electrostatic Discharge Damage” on page 205.
2. Press and release the power button to power off the router. Verify that the
POWER LED blinks and then turns off.
3. Align the notches in the connector at the rear of the PIM with the notches in
the PIM slot in the Services Router, and slide the PIM in until it lodges firmly
in the router.
CAUTION: Slide the PIM straight into the slot to avoid damaging the components
on the PIM.
4. Tighten the captive screws on each side of the PIM faceplate.
5. Insert the appropriate cables into the cable connectors on the PIM.
6. If necessary, arrange the cables to prevent them from dislodging or developing
stress points:
146 Replacing Hardware Components