Juniper Networks J4350 - Manual (Page 30)

J4350 and J6350 Services Router Getting Started Guide
In addition to the features described in subsequent sections, the
chassis includes the following features:
One pair of metal brackets can be mounted at the front or center of the
chassis. Use the brackets for mounting the chassis in a rack or cabinet.
Two protective earthing terminals, PEM nuts at the rear of the chassis.
One electrostatic discharge (ESD) point, a banana plug receptacle at the
front of the chassis.
CAUTION: Before removing or installing components of a functioning router, attach
an ESD strap to an ESD point and place the other end of the strap around your bare
wrist. Failure to use an ESD strap could result in damage to the router.
The router must be connected to earth ground during normal operation. The
protective earthing terminals on the rear of the chassis are provided to connect the
router to ground (see Figure 3). Additional grounding is provided to an AC-powered
router when you plug its power supply into a grounded AC power receptacle.
For additional safety information, see “Safety and Regulatory Compliance
Information” on page 201.
Figure 1: Front of J4350 and J6350 Chassis
POWER
PO WER ST ATUS
ALARM
HA
RESET
CONSOLE AUX USB
1
0
CONFIG
PORT 0
STATUS
PORT 1
STATU S
10/100/1000
g003800
ESD
point
Power
button
Physical Interface
Module (PIM) Blank
PIM panel Mounting
bracket Mounting
bracket
Console
port USB
ports LAN ports Auxiliary
port
1 4
5
6 2
3
SLOT N UMBE R
E
E E
E
10 J4350 and J6350 Services Router Hardware Features