Establishing basic connectivity, Chapter 7 – Juniper Networks J4350 User Manual
Page 113
Chapter 7
Establishing Basic Connectivity
The JUNOS software is preinstalled on the Services Router. When the router is
powered on, it is ready to be configured. If the router does not have a configuration
from the factory or your service provider, you must configure the software to
establish basic connectivity.
If you are setting up a Services Router for the first time, you can use either J-Web
Quick Configuration or a configuration editor to configure basic connectivity. For a
brief explanation of J-Web Quick Configuration and the J-Web and CLI configuration
editors, see “Services Router User Interface Overview” on page 49.
If you are setting up many Services Routers, autoinstallation can help automate
the configuration process. For more information about autoinstallation, see
“Configuring Autoinstallation” on page 125.
This chapter contains the following topics. For more information about basic
connectivity, see the JUNOS System Basics Configuration Guide.
Basic Connectivity Terms on page 93
Basic Connectivity Overview on page 94
Connecting to a Services Router on page 99
Configuring Basic Settings with J-Web Quick Configuration on page 105
Configuring Basic Settings with a Configuration Editor on page 108
Verifying Basic Connectivity on page 113
Basic Connectivity Terms
Before configuring basic connectivity, become familiar with the
terms defined in Table 34.
Basic Connectivity Terms
93