Removing a dram module – Juniper Networks J4350 User Manual

Page 176

J4350 and J6350 Services Router Getting Started Guide

Figure 45: J4350 and J6350 DRAM Location

DRAM

g003841

To modify the DRAM configuration, use the following procedures:

Removing a DRAM Module on page 156

Installing a DRAM Module on page 157

Removing a DRAM Module

NOTE: Depending on your configuration, the Services Router might have an empty
DRAM socket. If you are adding a DRAM module to the DRAM configuration,
proceed directly to “Installing a DRAM Module” on page 157.

To remove a DRAM module:

Place an electrostatic bag or antistatic mat on a flat, stable surface.

Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about
ESD, see the Getting Started Guide for your router.

156

Replacing Hardware Components

This manual is related to the following products:

J6350