Figure 36, Figure 36), Turn on the power to the management device – Juniper Networks J4350 User Manual
Page 122: Port to use (for example, Po wer st atus alarm ha, Com1, Power
J4350 and J6350 Services Router Getting Started Guide
6.
Turn on the power to the management device.
7.
Start your asynchronous terminal emulation application (such as Microsoft
Windows Hyperterminal) and select the appropriate
COM
port to use (for
example,
COM1
).
8.
Configure the port settings as follows:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
9.
Power on the router by pressing the power button on the front panel. Verify
that the
POWER
LED on the front panel turns green.
The terminal emulation screen on your management device displays the boot
sequence. When the router has finished booting, a login prompt appears.
10.
Log in as the user “root”. No password is required at initial connection, but you
must assign a root password before committing any configuration settings.
Figure 36: Connecting to the Console Port on the Services Router
POWE
R
PO
WER
ST
ATUS
ALARM
HA
RESE
T
CONS
OLE
AUX
USB
1
0
CONF
IG
PORT
0
STATU
S
PORT
1
STATU
S
10/10
0/100
0
g003510
RJ-45 rollover cable
Console port
Adapter
Serial port
1
4
5
6
2
3
SLOT
NUM
BER
E
E
E
E
102
Connecting to a Services Router