Juniper Networks J4350 - Manual (Page 120)

J4350 and J6350 Services Router Getting Started Guide
To connect to the J-Web interface through port 0 on the router (see Figure 35):
1. On the management device, such as a PC or laptop, you use to access the
J-Web interface, verify that the address of the port that you connect to the
router is set to one of the following:
An Ethernet address on the 192.168.1/24 subnetwork other than
192.168.1.1
An Ethernet address from a DHCP server
2. Turn off the power to the management device.
3. Plug one end of the Ethernet cable into the Ethernet port on the management
device.
4. Connect the other end of the Ethernet cable to the built-in Ethernet port
on the router.
5. Power on the router by pressing the power button on the front panel.
6. Wait until the STATUS LED on the front panel turns solid green.
7. Turn on the power to the management device. The router assigns an IP
address to the management device within the
192.168.1.0/24 subnetwork if the
device is configured to use DHCP.
8. From the management device, open a Web browser and enter the IP address
192.168.1.1 in the address field. The Set Up Quick Configuration page appears.
9. Configure basic settings for your router as described in “Configuring Basic
Settings with J-Web Quick Configuration” on page 105.
NOTE: You must manually configure the IP address for the management port
you are using before you save your initial configuration. When you save the
configuration for the first time, you will lose the connection to the router if you
have not manually configured the IP address. If you lose connection through the
management interface, you must connect through the console port.
100 Connecting to a Services Router