Juniper Networks J4350 - Manual (Page 164)

J4350 and J6350 Services Router Getting Started Guide
Tools and Parts Required
To replace hardware components, you need the tools and parts listed in Table 45.
Table 45: Tools and Parts Required
Tool or Part Components
Electrostatic bag or antistatic mat All
Electrostatic discharge (ESD)
grounding wrist strap All
Flat-blade screwdriver,
approximately 1/4 in. (6 mm) PIM
Phillips (+) screwdriver, number 2 Compact flash
Crypto Accelerator Module
DRAM modules
Power system components
Replacing the Console Port Cable
The RJ-45 port labeled CONSOLE on the Services Router’s front panel allows
you to connect the router to an external management device, such as a
laptop or a terminal server. For cable specifications, see “Network Cable
Specifications and Connector Pinouts” on page 185.
To replace the console port cable:
1. Locate an appropriate replacement cable and connector.
2. Plug the Ethernet connector at either end of the cable into the console port
on the front panel (see Figure 36).
3. Plug the connector at the other end of the cable into the external management
device. If you are connecting to a DB-9 serial port, use the provided RJ-45
to DB-9 serial port adapter.
Replacing a PIM
To remove or install field-replaceable Physical Interface Modules (PIMs) in a
Services Router, you must first power off the router. This section contains the
following topics:
Removing a PIM on page 145
Installing a PIM on page 146
144 Replacing Hardware Components