Juniper Networks J4350 - Manual (Page 216)

J4350 and J6350 Services Router Getting Started Guide
Table 60: RJ-45 Console Connector Pinout (continued)
Pin Signal Description
7 DSR Input Data Set Ready
8 CTS Input Clear to Send
Table 61 describes the DB-9 connector pinouts.
Table 61: DB-9 Console Connector Pinout
Pin Signal Direction Description
1 DCD <– Carrier Detect
2 RxD <– Receive Data
3 TxD –> Transmit Data
4 DTR –> Data Terminal Ready
5 Ground — Signal Ground
6 DSR <– Data Set Ready
7 RTS –> Request To Send
8 CTS <– Clear To Send
9 RING <– Ring Indicator
E1 and T1 RJ-48 Cable Pinouts
The E1 and T1 PIMs use an RJ-48 cable, which is not supplied with the PIM.
CAUTION: To maintain agency approvals, use only a properly constructed, shielded
cable.
Table 62 through Table 65 describe the RJ-48 connector pinouts.
Table 62: RJ-48 Connector to RJ-48 Connector (Straight) Pinout
RJ-48 Pin (on T1/E1
PIM) (Data Numbering
Form) RJ-48 Pin
(Data Numbering
Form)
Signal
1 1 RX, Ring, –
2 2 RX, Tip, +
4 4 TX, Ring, –
5 5 TX, Tip, +
196 E1 and T1 RJ-48 Cable Pinouts