Juniper Networks J4350 - Manual (Page 156)

J4350 and J6350 Services Router Getting Started Guide
3. Select Save it to disk and specify the file to which the license keys are
to be written.
4. Go on to “Verifying J-series License Management” on page 137.
Managing J-series Licenses with the CLI
To manage the J-series licenses with the CLI, perform the following tasks.
Adding New Licenses with the CLI on page 136
Deleting a License with the CLI on page 136
Saving License Keys with the CLI on page 137
Adding New Licenses with the CLI
To add a new license key to the Services Router with the CLI:
1. Enter operational mode in the CLI.
2. Enter one of the following CLI commands:
To add a license key from a file or URL, enter the following command,
specifying the filename or the URL where the key is located:
request system license add filename | url
To add a license key from the terminal, enter the following command:
request system license add terminal
3. When prompted, enter the license key, separating multiple license keys with a
blank line.
If the license key you enter is invalid, an error is generated when you press
Ctrl-D to exit license entry mode.
4. Go on to “Verifying J-series License Management” on page 137.
Deleting a License with the CLI
To delete a license key from the Services Router with the CLI:
1. Enter operational mode in the CLI.
2. Enter the following command for each license, specifying the license ID. You
can delete only one license at a time.
request system license delete license-id
136 Managing J-series Licenses with the CLI