Juniper Networks J4350 - Manual (Page 125)

Establishing Basic Connectivity
3. Select the COM port to which the modem is connected (for example, COM1 ).
4. Configure the port settings as follows:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
5. In the HyperTerminal window, enter AT .
An OK response verifies that the modem communicates successfully with
the COM port on the PC or laptop.
6. To dial the modem that is connected to the console port on the router, enter
ATDT remote-modem-number . For example, if the number of the modem connected
to the console port on the router is 0013033033030 , enter ATDT 0013033033030 .
The router login prompt appears.
7. Log in as the user “root”. No password is required at initial connection, but you
must assign a root password before committing any configuration settings.
Configuring Basic Settings with J-Web Quick Configuration
J-Web Quick Configuration allows you to configure basic settings. Figure 25
shows the Quick Configuration page for basic setup.
Before you configure the router, gather the information described
in “Before You Begin” on page 98.
To configure basic settings with J-Web Quick Configuration:
1. If you have not already done so, connect a management device to the ge-0/0/0
interface on port 0/0. For instructions, see “Connecting to the J-Web Interface”
on page 99.
2. If the Set Up Quick Configuration page is not displayed, select
Configuration>Quick Configuration >Set Up.
3. Enter information into the Set Up Quick Configuration page, as described in
Table 35.
4. Click one of the following buttons:
To apply the configuration and stay in the Set Up Quick Configuration
page, click Apply.
Configuring Basic Settings with J-Web Quick Configuration 105