ICP DAS USA MSM-6226 - Manual (Page 292)

Hardware Specifications
Standard Compliance: IEEE802.3ab / 802.3z / 802.3u / 802.3x
802.3z and 802.3ab compliant Gigabit Ethernet ports
Network Interface of Option transceiver :
Configuration Mode Connector Port
SFP.0LC.202 1000FDX *LC M-M 2(Option)
SFP.0LC.212.XX 1000FDX *LC S-M 2(Option)
SFP.0BL.621.20X 1000FDX *BiDi-LC S-M 2(Option)
GBI.ZSC.202 1000FDX *SC M-M 2(Option)
GBI.ZSC.212.XX 1000FDX *SC S-M 2(Option)
GBI.ZSC.621.20X 1000FDX *BiDi-SC S-M 2(Option)
* : Default module
Transmission Mode: 10/100Mbps support full or half duplex
1000Mbps support full duplex only
Transmission Speed: 10/100/1000Mbps for TP
1000Mbps for Fiber
Full Forwarding/Filtering Packet Rate: PPS (packets per second)
Forwarding Rate Speed
1,488,000PPS 1000Mbps
148,800PPS 100Mbps
14,880PPS 10Mbps
MAC Address and Self-learning: 8K address table entries,
256 VLAN table entries,
256 IP multicast table entries,
Buffer Memory: Embedded 256KB packet buffers and 128KB control memory.
Flow Control: IEEE802.3x compliant for full duplex
Backpressure flow control for half duplex
Cable and Maximum Length:
TP Cat. 5 UTP cable, up to 100m
1000Base-SX SC M-M
Up to 220/275/500/550m,
which depends on Multi-Mode Fiber type
1000Base-LX SC S-M Single-Mode Fiber, up to10/30/50Km
1000Base-FX WDM SC S-M Single Fiber, BiDi 20Km
Diagnostic LED:
System LED : Power
CPURUN
ACT (LEDSET)
FDX (LEDSET)
SPD (LEDSET)
Per Port LED:
10/100M TP Port 1 to 24 : LINK/ACT, FDX, SPD