Milan Technology MIL-SM2401MAF - Manual (Page 46)

38
stp-path-cost
[number]
Interface
configuration
mode
Use the
spanning-tree cost
interface
configuration
command to set the
path cost for
Spanning Tree
Protocol (STP)
calculations. In the
event of a loop,
spanning tree
considers the path
cost when selecting
an interface to
place into the
forwarding state.
Use the no form of
this command to
return to the default
value.
10 Mbps
– 100
100 Mbps
– 10
Switch (config)#
interface
fastEthernet 0/2
Switch (config-if)#
stp-path-cost 20
spanning-tree
forward-time
[seconds]
Global
configuration
mode
Use the
spanning-tree
forward-time global
configuration
command to set the
forwarding-time for
the specified
spanning-tree
instances. The
forwarding time
determines how
15 sec.
Switch (config)#
spanning-tree
forward-time 20