Milan Technology MIL-SM2401MAF - Manual (Page 35)

27
Bandwidth [in |
out] [value]
Interface
configuration
mode
Set bandwidth in or out
rate. The value rage is
(0~999), and zero of
the value is disable
(The module can’t be
setting)
Disable
Switch (config)#
interface
fastEthernet 0/1
Switch (config-if)#
bandwidth in 50
State [Enable |
Disable]
Interface
configuration
mode
Use the state interface
configuration
command to specify
the state mode of
operation for Ethernet
ports. Use the disable
form of this command
to disable the port.
Enable
Switch (config)#
interface
fastEthernet 0/1
Switch (config-if)#
state disable
show interface
configuration
Interface
configuration
mode
show interface
configuration status
Switch (config)#
interface
fastEthernet 0/1
Switch (config-if)#
show interface
configuration