beautypg.com

Zkhss1 for 1/4" panels – GE Monogram ZISB42D User Manual

Page 38

background image

38

This kit provides for the installation of Stainless Steel custom
handles on 1/4" thick decorator door panels. The door extru-
sions allow these custom handles to be secured to the door
structure, rather than to the custom panels. This kit contains
all the necessary parts for dispenser and non-dispenser
models.

Step 1:
Remove
Handles

• Open doors to 90

°

. Remove the screws from the full-

length handles of both doors.

• Retain screws, discard handles.

• Locate the 2" x 2" adhesive foam pads packed with

the refrigerator. Apply pads to the doors as shown.
Corner pads should be as close to inside corners as
possible.

Note: It is best that 2 people install this kit.

Tools and materials required:
• #2 Phillips screwdriver
• Drill and 1/8", 9/32" bits
• Custom door panels
• Safety glasses
• Center punch
• Masking tape
• Hammer
• Pencil
• 1/2" thick 12" x 12" min. piece of plywood

to protect floor when drilling

• For stainless steel panels wear gloves to

protect against sharp edges.

Parts List:
A. Fresh food door extrusion
B. Freezer door extrusion
C. 2 Stainless tubular handles
D. 10 Spacer rings (for Stainless panels ONLY)

(8 required, 2 extra)

E. 8 Handle standoffs
F. 10 Screws for mounting handle standoffs
(8 required, 2 extra)
G. 10 Set screws (8 required, 2 extra)
H. 3/32" Allen wrench for set screws

A

B

D

E

G

H

F

C

Note: If a custom collar is to be used, order ZWCD1 Trim Kit
for 42" and 42" wide models. Order ZWCD2 for 48" wide

models.

ZKHSS1 for 1/4" Panels

Tubular Stainless Steel Handles

ZKHSS1

INSTALLATION

This manual is related to the following products: