GE Monogram ZISB42D - Manual (Page 37)

37
ZKHT1 Trim Kit (For 3/4" Panels)
Support for Custom Handles
• Drill clearance holes through the handle bracket and
the dispenser trim.
• Install screw(s) long enough to pass through the
handle bracket, dispenser trim and into the
custom handle.
Option 2 Installation
Step 2
Install
custom handle
Step 3
Mount
assembled
dispenser
trim
Important: The handle
bracket must be secured to the
steel door. If it is not secured
properly, the dispenser trim will
pull away from the door.
Again, refer to ZKT42 trim kit, Option 2.
• Follow Step 4 to install freezer door panels and bottom
trim.
• Slide freezer handle side extrusion in between panels
and steel door. Secure with screws.
• To install fresh food handle, follow the same proce-
dure as in Option 1.
• Mount assembled dispenser trim with handle onto
the door.
• Drive 2 screws through the top and bottom of the
handle bracket into the steel door.
• Re-install 3 screws at top and bottom of dispenser
trim.
Handle Bracket
Handle Bracket
Custom Handle
Dispenser Trim
Dispenser Trim
Secure
Handle
Bracket
With
Screws Secure
Assembled
Dispenser
Trim
With
Screws
Freezer
Handle Side
Extrusion
ZKHT1
INSTALLATION