beautypg.com

Zkht1 trim kit (for 3/4" panels) – GE Monogram ZISB42D User Manual

Page 34

background image

• Secure the panel to the trim temporarily by driving

2 screws through the back side of the trim at the top.

• Slide door extrusion in between panel and steel door.

Temporarily secure with 2 screws.

• Drill 1⁄16" pilot hole through the panel until it starts

into the aluminum extrusion. This will mark the
matching location for drilling a clearance hole when
assembling the extrusion, panel and handle.

3/4" Min.
1-1/2" Max.

ZKHT1 Trim Kit (For 3/4" Panels)

Support for Custom Handles

Step 1
Temporarily
mount
door panels

Step 2
Locate
position
of handles

• Place the prepared 3/4"custom door panels on the

bottom trim with support bracket tabs inserted into
slots.

• Push the panel back against the steel door, making

sure panel is flush with hinge side trim.

• Determine the desired location of the custom handles

and carefully mark centerlines of the screw holes.
The handles must be located 3/4" to 1-1⁄2" from the
end of the extrusion.

• Again, with both doors closed, check centerlines of

the screw holes to be sure they are parallel to the
edge of the door, and level with opposite door.

34

ZKHT1

INSTALLATION

This manual is related to the following products: