FARGO electronic HDPii - Manual (Page 87)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 5-14
Troubleshooting with the LCD Error Message Table (continued)
LCD Error Message Cause Solution
No iClass Encoder
(PC Error Message
No. 177)
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type. You are trying to send
encoding data, but the Printer
is not configured with this
Encoder type.
No Mag Module
(PC Error Message
No. 31)
MAG encoding job sent to
Printer without a MAG
encoder.
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type.
No MiFare Encoder
(PC Error Message
No. 203)
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type. To cancel, click on Cancel
Print.
No Prox Encoder
(PC Error Message
No. 32)
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type. To cancel, click on Cancel
Print.
No Ribbon
(PC Error Message
No. 25)
No Ribbon is installed in the
Printer.
OR
The Ribbon RFID tag is bad. Install the correct Ribbon and
press the Resume button
located o the Printer’s LCD
display.
To cancel the print, press the
Cancel Print button from the
Driver's display dialog and the
Cancel button located on the
Printer's LCD display.