FARGO electronic HDPii User Manual
Page 313
RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1)
10-32
Cleaning the Printer Platen Roller and Card Feed Rollers
Perform this procedure approximately every 1,000 prints to maintain a consistent print
quality. (Note: The Card Feed Rollers move the card throughout the print process. Rollers
should be kept clean to prevent card jams and card contamination. This cleaning process will
ultimately lead to better print quality and extended Printhead life.)
Step Procedure
1
From the Driver, click on the Toolbox button to bring up the Clean Printer tab.
2
Follow the instructions from the CLEAN PRINTER tab on the Driver. See
Display A below.
(Note: If your Printer is equipped with a Magnetic Encoder, you must insert
the Cleaning Card with the printed side up and with a small Liner Strip towards
the front of the Printer. See Display B below.)
3
After the cleaning process is completed, the Cleaning Card will exit the Printer
at the Input Hopper.
4
Replace the printing supplies and close the Print Stations after the Rollers are
clean and completely dry.