FARGO electronic HDPii - Manual (Page 83)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 5-10
Troubleshooting with the LCD Error Message Table (continued)
LCD Error Message Cause Solution
Head Resistance
(PC Error Message
No. 6)
The EE setting in Driver for
head resistance is out of
range. Enter a value for head
resistance in the EE settings in
the Driver.
Reset the correct value
according to the steps in the
Troubleshooting Section.
If this problem persists, call for
technical assistance.
Head Sensor Error
(PC Error Message
No. 8)
The Printhead Temperature
Sensor is not functioning or
is not connected properly.
OR
The Printhead is not cooling
properly. If the problem persists, call for
technical assistance.
Head Voltage Error
(PC Error Message
Nos. 103 and 105)
A hardware fault has
prevented setting the correct
Printhead voltage. Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Headlift Error
(PC Error Message
Nos. 102, 103, 104,
and 105)
This is a problem with the
Printhead Lift or Transfer
Roller Headlift. Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Heater Error
(PC Error Message
No. 161)
The Transfer Heater Roller is
too hot. Reset the Printer and try
again.
If this problem persists, call for
technical assistance.