FARGO electronic HDPii - Manual (Page 80)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 5-7
Troubleshooting with the LCD Error Message Table (continued)
LCD Error Message Cause Solution
Cover is Open
(PC Error Message
No. 46)
The Cover was left open. Ensure that the Cover is
properly closed.
E-Card Encoder
Startup Error
(PC Error Message
No. 141)
A problem was detected
during Printer start-up. Reset the Printer and try
again. If this problem persists,
call for technical assistance.
E-Card Startup Error
(PC Error Message
No. 141)
A problem was detected
during Printer start-up. Reset the Printer and try
again. If this problem persists,
call for technical assistance.
EEPROM Corrupt
(PC Error Message
Nos. 38, 39, 40, and
144)
EEPROM restored with
factory default values. If changes were made, then go
into the setting values and
reset these numbers.
Ejecting Card
(PC Error Message
No. 72)
The card has been ejected
already. Click OK to clear the
message. The user might want
to know that a card has been
sent to the reject bin, or out of
the printer, and is either
incomplete or posses a
security risk if not disposed of
properly.