Furuno GP-3500F User Manual
Page 186
11. VIDEO SOUNDER OPERATION
11-14
11.4.3
Shifting the basic range
The shift function determines the start depth of the picture. Start depth (shift) is
shown at the top of the screen.
Basic range
Shift
Principle of shift
Note:
This function is not available when the AUTO mode is on.
1. Press the [SHIFT] key to show the SHIFT window.
SHIFT
Shift window
2. Rotate the [ENTER] knob to set shift value.
Note 1:
This setting must be done within 10 seconds after pressing the [SHIFT]
key, otherwise the window will be erased.
Note 2:
If the shift value is larger than the distance to the bottom, nothing
appears on the display.
Note 3:
The [SHIFT] key can be programmed for other function. See paragraph
11.16.
See also other documents in the category Furuno GPS receiver:
- MARINE RADAR 1953C (100 pages)
- GP-1650D (2 pages)
- GP-1650WD (96 pages)
- GP-1650W (96 pages)
- NAVNET 1943C-BB (92 pages)
- GD-3300 (137 pages)
- DUAL GPS GP-150-DUAL (130 pages)
- GP-1650WF (113 pages)
- CH-300 (124 pages)
- NX-300 (65 pages)
- NX-300 (2 pages)
- GP-1850WDF (115 pages)
- GP-3500 (192 pages)
- GP-1850WD (44 pages)
- GP-1850W (98 pages)
- GP-1850WD (98 pages)
- GP-1850W (4 pages)
- GP-1850W (98 pages)
- INTERFACE UNIT IF-2500 (12 pages)
- GP-31 (2 pages)
- GP-33 (98 pages)
- GP-7000 (28 pages)
- GP-7000 (2 pages)
- GP37 (2 pages)
- GP-90 (36 pages)
- CI-35 (69 pages)
- GP-1850DF (63 pages)
- GP-1850F (110 pages)
- GP-30 (2 pages)
- FCV-30 (110 pages)
- BACK GP-80 (103 pages)
- LC-90 MARK-II (2 pages)
- GP-1650W (44 pages)
- DD-80 (119 pages)
- RP-250 (73 pages)
- GP-1650 (94 pages)
- GP-185F (4 pages)
- GP-1600F (97 pages)
- GP-1850D (94 pages)
- GP-7000F (132 pages)
- GP-7000F (52 pages)
- GP-36 (81 pages)
- GP-150-DUAL (123 pages)
- GP-80 (37 pages)
- 1650WDF (4 pages)