Furuno GP-3500F - Manual (Page 130)

9. CUSTOMIZING YOUR UNIT
9-16
MARK STATUS
Turns the mark data on or off. When ON is selected, place the cursor on a mark
to show the mark data box.
OWN SHIP’S MARK
Selects own ship’s mark size from among LARGE, SMALL or SHIP.
“SHIP” is selected to indicate the length and width of your vessel, with SHIP’S
LENGTH, SHIP’S WIDTH, ANTENNA POSITION Va and ANTENNA POSITION
Hb below.
SHIP’S LENGTH, SHIP’S WIDTH
Sets the ship’s length and width. (See the installation manual.)
ANTENNA POSITION Va, ANTENNA POSITION Hb
Sets the antenna unit position. (See the installation manual.)
9.4 NAVIGATOR SETUP Menu
The NAVIGATOR SETUP menu chooses the source of navigation data and sets
up the built-in GPS receiver.
1. Press the [MENU] key to show the main menu.
2. Press the [0] key to show the SYSTEM SETUP menu.
3. Press the [2] key to show the NAVIGATOR SETUP menu.
0-2. NAVIGATOR SETUP
SELECT NAV SOURCE 1. INT 2. EXT 3. EXT LORAN-C
4. ALL
LOCAL TIME (INT GPS) +00:00
LOCAL TIME (EXT NAV) +00:00
GEODETIC DATUM WGS-84
POSITION SMOOTHING 000
SPEED SMOOTHING 000
SPEED AVERAGING (INT) 060
SPEED AVERAGING (EXT) 060
LATITUDE OFFSET
0.000' N
LONGITUDE OFFSET 0.000' E
DISABLE SATELLITE _ _ _ _ _ _
DEFAULT LATITUDE 45˚ 35.000' N
DEFAULT LONGITUDE 125˚00.000'W
ANTENNA HEIGHT 05 m
GPS FIX MODE 1. 2D 2. 2D/3D
DGPS/WAAS 1. DGPS 2. WAAS 3. AUTO 4. OFF
DGPS/WAAS ALARM 1. YES 2. NO
DGPS BEACON STATION 1. AUTO 2. MANUAL
SELECT FREQUENCY 286.0 kHz
DGPS BAUD RATE 1.50 2. 100 3. 200
WAAS SEARCH 1. AUTO 2. MAN 134
CORRECTIONS DATA SET 02
TURN KNOB TO SELECT MENU.
SELECT THE ITEM OF EACH MENU BY TRACKBALL.
Navigator setup menu