Furuno GP-3500F - Manual (Page 133)

9. CUSTOMIZING YOUR UNIT
9-19
DEFAULT LATITUDE, DEFAULT LONGITUDE
The default latitude and longitude position is Seattle, U.S.A. (45°35.000’N,
125°00.000’W). When the unit is turned on for the first time it begins searching
for its actual position. To lessen the time required to find position, you may enter
your position manually. Use the [CURSOR ON/OFF] key to switch co-ordinate.
ANTENNA HEIGHT
Enter the height of the antenna unit above sea surface. For further details, refer
to the installation manual.
GPS FIX MODE
You can choose the position-fixing mode from 2D or 2D/3D. When selecting
2D/3D, 2D or 3D is automatically chosen depending on the number of available
satellites. (3D requires four or more satellites.)
DGPS/WAAS
Choose the position-fixing method among DGPS, WAAS and AUTO. DGPS
requires the optional DGPS receiver board. For WAAS, see the “WAAS Facility”
at the back of this manual.
AUTO fixes position by WAAS when DGPS correction data is not available.
For normal GPS positioning, select “OFF.”
DGPS/WAAS ALARM
This alarm alerts you (by audible and visual alarms) when the WAAS or DGPS
signal is lost.
YES: Alarm sounds when the position fixing method is switched from WAAS to
DGPS or vice versa.
NO: Alarm sounds once when WAAS or DGPS signal is lost.
DGPS BEACON STATION
DGPS reference station can be searched automatically or manually. For manual
search, select MANUAL here, and set frequency of DGPS reference station.
1. Rotate the [ENTER] knob to select DGPS BEACON STATION.
2. Press the [2] key to select “2. MANUAL.”
3. Rotate the [ENTER] knob to choose SELECT FREQUENCY.
4. Roll the trackball in left-right direction to set the station of DGPS reference
station which is the nearest to own ship.
DGPS BAUD RATE
Selects the transmission rate of the DGPS reference station nearest you, among
50, 100 or 200 (bps). This setting is only effective when DGPS BEACON
STATION is “MANUAL.”