Furuno GP-3500F - Manual (Page 168)

10. RECORDING & PLAYING BACK DATA
10-16
5. To download mark/line data, rotate the [ENTER] knob to select MARKS &
LINES of TRANSFER TO PC.
6. Press the [1] key to select “1. YES.”
7. To download waypoint/route data, rotate the [ENTER] knob to select
WAYPOINTS & ROUTES of TRANSFER TO PC>.
8. Press the [1] key to select “1. YES.”
9. Set RS-232C as follows.
a) Rotate the [ENTER] knob to select BAUD RATE.
b) Roll the trackball in left-right direction to select the baud rate among 4800,
9600, 19200 and 38400.
c) Rotate the [ENTER] knob to select CHARACTER LENGTH.
d) Roll the trackball in left-right direction to select the character length: 7 BITS
or 8 BITS.
e) Rotate the [ENTER] knob to select STOP BIT.
f) Roll the trackball in left-right direction to select the stop bit: 1 BIT or 2 BITS.
g) Rotate the [ENTER] knob to select PARITY.
h) Roll the trackball in left-right direction to select the parity from among EVEN,
ODD and NONE.
10. Rotate the [ENTER] knob to select TRANSFER TO PC.
11. Press the [1] key to select “1. YES.”
The following message appears.
OUTPUT DATA TO PC.
ARE YOU SURE?
YES ... PRESS KNOB
NO ... PRESS CLEAR KEY
12. Press the [ENTER] knob.
13. When the downloading is completed, press the [ENTER] knob.
14. Press the [MENU] key several times to close the menu.