Furuno GP-3500F - Manual (Page 147)

9. CUSTOMIZING YOUR UNIT
9-33
9.7 I/O PORT SETUP Menu
This menu sets up the I/O ports, and should be done at the installation. Note that
the data transfer between this unit and external equipment may be wrong after
changing this menu settings. Be sure the ports are correctly set. Improper setting
may prevent proper transfer of data.
1. Press the [MENU] key to show the main menu.
2. Press the [0] key to show the SYSTEM SETUP menu.
3. Press the [5] key to show the I/O PORT SETUP menu.
0-5. I/O PORT SETUP
NMEA I/O PORT 1
NMEA FORMAT
1. NMEA0183 Ver 1.5 2. Ver 2.0
TLL OUTPUT 1. ON 2. OFF
L/L FORMAT 1.DD˚MM.MM' 2.DD˚MM.MMM'
3.DD˚MM.MMMM'
OUTPUT DESTINATION 1. ON 2. OFF
SELECT OUTPUT SENTENCE 1. ON 2. OFF
NMEA I/O PORT 1
NMEA FORMAT
1. NMEA0183 Ver 1.5 2. Ver 2.0
TLL OUTPUT 1. ON 2. OFF
L/L FORMAT 1.DD˚MM.MM' 2.DD˚MM.MMM'
3.DD˚MM.MMMM'
OUTPUT DESTINATION 1. ON 2. OFF
SELECT OUTPUT SENTENCE 1. ON 2. OFF
RS232C FORMAT
BAUD RATE
1. 4800 2. 9600 3. 19200 4. 38400
CHARACTER LENGTH 1. 7 BIT 2. 8 BIT
STOP BIT 1. 1 BIT 2. 2 BITS
PARITY 1. EVEN 2.ODD 3. OFF
NMEA FORMAT 1. NMEA0183 Ver 1.5 2. Ver 2.0
L/L FORMAT 1.DD˚MM.MM' 2.DD˚MM.MMM'
3.DD˚MM.MMMM'
OUTPUT DESTINATION 1. ON 2. OFF
SELECT OUTPUT SENTENCE 1. ON 2. OFF
TURN KNOB TO SELECT MENU.
SELECT THE ITEM OF EACH MENU BY TRACKBALL.
I/O port setup menu