Fortinet FortiGate 4000 - Manual (Page 63)

NAT/Route mode installation Using the setup wizard
FortiGate-4000 Installation and Configuration Guide
63
Out of band management interface
Use Table 22 to record the IP address, netmask, and default gateway of the
FortiGate-4000 out of band management interface if you are configuring this interface
during installation.
.
Using the setup wizard
From the web-based manager, you can use the setup wizard to complete the initial
configuration of the FortiGate unit. For information about connecting to the web-based
manager, see
“Connecting to the web-based manager” on page 44 .
Starting the setup wizard
1 In the web-based manager, select Easy Setup Wizard (the middle button in the upper-
right corner of the web-based manager).
2 Select the Next button to step through the wizard pages.
3 Use the information that you gathered in Table 20 on page 61 to fill in the wizard fields.
You can also use the information in Table 21 on page 62 .
4 Confirm the configuration settings, and then select Finish and Close.
Reconnecting to the web-based manager
If you connected to the FortiGate unit using the internal interface and you changed the
IP address of the internal interface while you were using the setup wizard, you must
reconnect to the web-based manager using a new IP address. Browse to https://
followed by the new IP address of the internal interface. Otherwise, you can reconnect
to the web-based manager by browsing to https://192.168.1.99.
The IP address of the out of band management interface is not changed from the
setup wizard. If you connected to the FortiGate unit using the out of band
management interface you do not have to reconnect after completing the wizard.
You are now finished the initial configuration of your FortiGate unit, and can proceed
to
“Completing the configuration” on page 66 .
Table 22: Out of band management interface (Optional)
IP: _____._____._____._____ Netmask: _____._____._____._____
Default Gateway: _____._____._____._____
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For example, for each server
located on the Internal network the FortiGate unit adds an External->Internal firewall policy.