Configuring a windows 98 client for pptp – Fortinet FortiGate 4000 User Manual
Page 262
262
Fortinet Inc.
Configuring PPTP
PPTP and L2TP VPN
6
Set Service to match the traffic type inside the PPTP VPN tunnel.
For example, if PPTP users can access a web server, select HTTP.
7
Set Action to ACCEPT.
8
Select NAT if address translation is required.
You can also configure traffic shaping, logging, and antivirus and web filter settings for
PPTP policies.
9
Select OK to save the firewall policy.
Configuring a Windows 98 client for PPTP
Use the following procedure to configure a client computer running Windows 98 so
that it can connect to a FortiGate PPTP VPN. To configure the Windows 98 client, you
must install and configure Windows dialup networking and virtual private networking
support.
To install PPTP support
1
Go to Start > Settings > Control Panel > Network.
2
Select Add.
3
Select Adapter.
4
Select Add.
5
Select Microsoft as the manufacturer.
6
Select Microsoft Virtual Private Networking Adapter.
7
Select OK twice.
8
Insert diskettes or CDs as required.
9
Restart the computer.
To configure a PPTP dialup connection
1
Go to My Computer > Dial-Up Networking > Configuration.
2
Double-click Make New Connection.
3
Name the connection and select Next.
4
Enter the IP address or host name of the FortiGate unit to connect to and select Next.
5
Select Finish.
An icon for the new connection appears in the Dial-Up Networking folder.
6
Right-click the new icon and select Properties.
7
Go to Server Types.
8
Uncheck IPX/SPX Compatible.
9
Select TCP/IP Settings.
10
Uncheck Use IP header compression.
11
Uncheck Use default gateway on remote network.
12
Select OK twice.