Restarting the fortigate unit, Shutting down the fortigate unit, System status – Fortinet FortiGate 4000 User Manual
Page 118
118
Fortinet Inc.
Restarting the FortiGate unit
System status
4
Select OK.
The FortiGate unit changes operation mode.
5
To reconnect to the web-based manager you must connect to the interface configured
by default for management access.
By default in NAT/Route mode, you can connect to the internal interface. The default
Transparent mode management IP address is 192.168.1.99.
See
“Connecting to the web-based manager” on page 44
or
Command Line Interface (CLI)” on page 47
.
Restarting the FortiGate unit
1
Go to System > Status.
2
Select Restart.
The FortiGate unit restarts.
Shutting down the FortiGate unit
You can restart the FortiGate unit after shutdown only by turning the power off and
then on.
1
Go to System > Status.
2
Select Shutdown.
The FortiGate unit shuts down and all traffic flow stops.
System status
You can use the system status monitor to display FortiGate system health information.
The system health information includes memory usage, the number of active
communication sessions, and the amount of network bandwidth currently in use. The
web-based manager displays current statistics as well as statistics for the previous
minute.
If the FortiGate unit contains a hard disk, the system status monitor displays the
capacity of the hard disk and the amount of used and free space on the hard disk.
You can also view current virus and intrusion status. The web-based manager
displays the current number of viruses and attacks as well as a graph of virus and
attack levels over the previous 20 hours.
In each case you can set an automatic refresh interval that updates the display every
5 to 30 seconds. You can also refresh the display manually.
•
•
Viewing sessions and network status
•