Fortinet FortiGate 4000 - Manual (Page 36)

36
Fortinet Inc.
Rear panel features Getting started
The internal switched interface module provides two gigabit connections to the
internal interfaces of the FortiBlade-4010 modules installed in the FortiGate-4000
chassis. The external switched interface module provides two gigabit connections to
the external interfaces of the FortiBlade-4010 modules installed in the FortiGate-4000
chassis. The switched interface modules act as layer 2 switches.
Figure 13: Switched interface module
Table 10: Switched interface connectors
Connector Description
LAN1 and LAN2 10/100/1000 Mbit copper interfaces.
SFP Small form-factor pluggable (SFP) interface. You can install
optical connectors into these interfaces to connect the
FortiGate-4000 unit to your optical network.
ON OFF Turn the switched interface module on and off.
Table 11: Pass-through interface module LEDs
LED State Description
Interface LEDs
Amber The correct cable is in use and the connected equipment has
power.
Flashing
Amber
Network activity at this interface.
Green The interface is connected at up to 1000 Mbps.
Status Green System fault. Contact Fortinet technical support.
LAN 1 LAN 2 COM
SFP SFP HiGig OUT HiGig IN
ON OFF
Gigabit copper
interfaces
not used
SFP
interfaces
Status
LED
not used
On/off
switch
Mounting Knot
Mounting Knot