Sekonic Speedmaster L-858D-U Light Meter - Manual (Page 101)

87
5. Measuring
5-2-4 Cord Multi (Cumulative) Flash Mode
This Measuring Mode is used when the light generated by the flash at one time is
inadequate for the desired F-stop setting. Repeated flash pops can be accumulated
until the desired F-stop value is displayed. The measured value (F-stop) is displayed
for each trigger of the flash. The cumulative count is displayed in the Status/Title
field. The cumulative count is infinite. Up to 99 times is displayed in the Status/
Title field, however, the cumulative count returns to 0(zero) for more than 100 times
(0=100, 1=101, 2=102, etc.).
1) Measuring
Operation
1.
Connect the synchro cord (sold
separately), which is connected to
the flash, to the meter.
(  P195)
Connect the synchro cord (sold separately) to
the meter's Synchro Terminal
b
.
2.
Touch the Measuring Mode Icon on
the Measuring Screen.
The Measuring Mode Screen is displayed.
3.
Touch the icon ( ) on the Measuring Mode Screen.
When it is selected, the display changes to the Measuring Screen.
Measuring Screen Measuring Screen
Measuring
Mode Icon
Measuring Mode Screen
4.
Set the light receiving method.
Switch to the Incident light, extended lumisphere ( )/retracted lumisphere ( ), or
reflected light. (  P32 , P37)
Synchro Terminal
b
Synchro Cord (sold separately)