Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 92)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
CUSTOMIZING THE WORK SCREEN / 83
CONTROL RATE CHANNELS 1-2
Control Rate Channels 1-2 display the channel actual application rates
depending on channel setup. The channels calculated flow rate displays.
– When the master/control switch is OFF, the rate displays in a small
font.
– When the master/control switch is ON, the rate displays in a large
font.
– When the channels target rate is adjusted using the Inc/Dec or
Preset Table Rate function, the new target rate is displayed for 5
seconds followed by the actual rate.
– This Data Item displays on an entire row of the Work screen.
CONTROL SCAN
Control Scan displays all active control channels sequentially showing the
actual rate in its respective units depending on channel setup, and the Inc/
Dec value or preset table rate for each channel in five-second intervals.
This Data item will display on an entire row on the Work screen.
POP ROW SCAN
Pop Row Scan displays all active seed rows population in seeds per acre
(or seeds/Ha) for each detected seed sensor. The value to the left side
displays the current row number being scanned. The value on the right is
the population data. The scans continue sequentially in four-second
intervals unless a particular row number is selected for continuous view.
This Data Item will display on an entire row of the Work screen.
POP MIN MAX ROW SCAN
Pop Min Max Scan alternately displays the seeding row with the minimum
population and the seeding row with the maximum population in seeds per
acre (or seeds/Ha). The value to the left side displays the current row
number. The value to the right is the population data. Dwell time for each
display is four seconds. This Data Item displays on an entire row of the
Work screen.